14. December 2017
Dow Pharma Solutions demonstrated its commitment to advancing the pharmaceutical sciences by exhibiting research findings in a range of posters at the 2017 AAPS show in San Diego, CA. Please find below links to copies of our presented posters.
24. November 2017
To avoid frequent drug administration, PLGA-based monolithic filament-shaped implants were prepared. In this study, the effect of different formulation variables was studied, namely: type of PLGA (PLGA 502 and PLGA 503), type of drug (the lipophilic Prednisolone acetate, PA and the hydrophilic Propranolol Hydrochloride, PH) and drug loading (10 and 30% w/w). PLGA 503-based implants showed a lower water uptake, lower mass loss and erosion, slower drug release, and better mechanical properties and
30. October 2017
The purpose of this work was to investigate the effect on the dissolution behavior when silica was added in different ways. The solid dispersion was prepared by hot-melt extrusion (HME) using indomethacin (IND) as a model drug and Kollidon VA64 as a carrier.
15. June 2017
Drug taste masking is a crucial process for the preparation of pediatric and geriatric formulations as well as fast dissolving tablets. Taste masking techniques aim to prevent drug release in saliva and at the same time to obtain the desired release profile in gastrointestinal tract.
09. June 2017
The main objective of this novel study was to develop chlorpheniramine maleate orally disintegrating films (ODF) using hot-melt extrusion technology and evaluate the characteristics of the formulation using in vitro and in vivo methods.
05. June 2017
Different types of ground hot-melt extrudates loaded with 10, 20 or 30 % of the poorly water-soluble drug tadalafil were prepared and characterized in vitro and in vivo (in rats). Soluplus was used as an amorphous carrier material, whereas mannitol and lactitol were studied as crystalline matrix formers
31. May 2017
Three dimensional printing technology is gaining in importance because of its increasing availability and wide applications. One of the three dimensional printing techniques is Fused Deposition Modelling (FDM) which works on the basis of hot melt extrusion–well known in the pharmaceutical technology